Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

AWR microwave office question

Status
Not open for further replies.

young.microwave.eng

Full Member level 3
Joined
Oct 22, 2008
Messages
150
Helped
11
Reputation
22
Reaction score
10
Trophy points
1,298
Activity points
2,310
hi every one
I'm going to draw the PCB of some transistor in microwave offic and save it to library to use in future.would you please help me ?
 

eoncu

Junior Member level 1
Joined
Feb 18, 2009
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,392
i am trying to desing a simple two-way wilkinson power divider by using AWR.I calculated the widths and lengths of the microstrip lines.And i draw them on the EM simulation layout.But i couldnt place the isolation resistor (2Zo) between two arms of the circuit.How can i describe resistance between two points on the design in EM Simulation layout in AWR.In CST user can specify RLC values between any points on the structure.But in AWR i couldnt find a way to describe.
 

young.microwave.eng

Full Member level 3
Joined
Oct 22, 2008
Messages
150
Helped
11
Reputation
22
Reaction score
10
Trophy points
1,298
Activity points
2,310
dear eoncu
I've designd some power dividers using microwave office.but I did not use EM simulator.you cand simulate using
schematics and see the layout.I schematics you can add 2Z0 resistor.for sure the result is reliable.I made the simulated schematic and mesure the result.for sure this method can help you
 
  • Like
Reactions: eoncu

    eoncu

    points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top