Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Area vs operating frequency in ASIC synthesis

Status
Not open for further replies.
A

akash singh

Newbie level 5
Newbie level 5
Joined
Jun 14, 2013
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
50
Hi All,

I am trying Synopsys dc tool for synthesizing my design. I tried different operating frequencies and observed the design area. Normally area should increase with increasing operating frequency but in my case design area for 220 MHz is somewhat greater than the area at 240 MHz. How is it possible??

Combinational area for 240 MHz is greater than 220 MHz but non combinational area for 220 MHz is greater.

Thanks in advance!

PS: Design area doesn't include net area.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top