hi, yes i need output with full freq band,i will use bandpass filter at each wilkinson output to seperate different bands, so plz if u provide me this type of divider lot of thnkx
---------- Post added at 19:40 ---------- Previous post was at 19:36 ----------
i ned wilkinson divider which divide uwb antenna output in four parts when i use it in front of uwb antenna
This design makes no sense to me. Why not use a simple frequency splitter, instead if difficult broadband power splitter followed by band pass filters?
This design makes no sense to me. Why not use a simple frequency splitter, instead if difficult broadband power splitter followed by band pass filters?
Above, you wrote that you have four different receiver bands. If that is true, it makes no sense to split the full wideband signal (with >6dB loss) and then filter after splitting. That would be really inefficient. Instead, you should design a frequency selective splitter, which can then have less insertion loss.
hi sir, i if u hav any simulatd file in hfss or ads of 1-4 wilkinson power divider :freq operation 3-10 GHZ,plz upload ,i really need ths
it not necessary that specifications should exact.
hi sir, i if u hav any simulatd file in hfss or ads of 1-4 wilkinson power divider :freq operation 3-10 GHZ,plz upload ,i really need ths
it not necessary that specifications should exact.
3-10G bandwidth is wide and not easy.
Even you get the simulation, you maybe can't get the desired results if you don't know the electromagnetics field theory.