That will only change which part will be used. So if I select 1, every 'channel' uses part 1 of the component. Select 2 and every 'channel' uses part 2. I never get different channels using the same component.
Thanks,
Jim
- - - Updated - - -
Please excuse the incompleteness of the design, I am just trying to figure out how to use Altium and will finish the design later.
Anyway, here are some pics of what is going on:
TopSheet is where I define the sheet with a repeat command:
The current sensor sheet:
The properties of the Amplifier:
One of the circuits after compiling:
Properties of the Amplifier after compiling:
Altium seems to create new components for each channel based on the name of the channel, making it impossible for me to just tell it to use a different part from a component in another channel.
Maybe I am just approaching the problem wrong?
Thanks,
Jim