rehakm
Junior Member level 1
Hi,
I often need to create custom footprint for new component and I need to check if it fits well. In OrCAD I was used to print it 1:1 on paper and align component on and eventually do a fine tune. Now in altium PCB library editor I can see that menu/file/print is grayed out so I can't print. I had to put a footprint on PCB and then print it but it cost more clicks & time. Is there a better way to do it?
I often need to create custom footprint for new component and I need to check if it fits well. In OrCAD I was used to print it 1:1 on paper and align component on and eventually do a fine tune. Now in altium PCB library editor I can see that menu/file/print is grayed out so I can't print. I had to put a footprint on PCB and then print it but it cost more clicks & time. Is there a better way to do it?