Altium Designer: Back annotation (update schematic with net changes from PCB)

Status
Not open for further replies.
B

backdrill

Member level 2
Joined
May 26, 2012
Messages
48
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,568
Hello everyone,

I would like to seek advice on the proper way to doing back annotation with Altium Designer.
What is the proper way to update a schematic from PCB with net name changes?
 

In pcb,tools...> Re Annotate, there itself select particular position press ok here one .WAS file will be generate, After that go to schematics tools...> back annotate schematics then select corresponding .WAS file. and press Accept changes. Just show in below images
 
Hi,

Tools/Re-annotate
In PCB Editor
Design/update schematics go to schematics compile it.

Again In Schematic Editor
Design/update PCB
 
I am getting 0kb .WAS file generated from the Re-annotate command execution.
It won't allow me to back annotate the schematic. Is there a missing setup?
 

Oh! But re annotate should be generate .was file with data, can i share ur pcb ?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…