Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Altium Board edge edititng

Status
Not open for further replies.

K.Srikanthreddy

Junior Member level 2
Junior Member level 2
Joined
Dec 8, 2011
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,392
Hi all!!!!!!!!!!

I need to provide sharp edge(not the corner of the board) on my pcb which has to be used as a male connector with connecting pads in top and bottom layer.
So, please suggest me how to sharpen top and bottom layer.

Thanks in advance!!!
K.Srikanth Reddy
 

didnt get you clearly - what does 'sharpen ' mean
do u want to have the edges to end in a > instead of a flat | surface
or do you want to mount a 2.5mm header along the edge of PCB .. soldering on both top and bottom layers
 

"do u want to have the edges to end in a > instead of a flat | surface"

You are 100% correct, this is what I am looking for.

Thanks and regards
 

you only need to draw a line in top and bottom overlay to indicate start position of tapering
the important part here is not design .. but the place where you want to have the pcb's done - if they have this service / capability

alternately you may also mention the purpose .. to allow people here at forum give you other possible options
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top