Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADS2009u1 & FEM engine (Linux)

Status
Not open for further replies.

Chinaski

Advanced Member level 4
Joined
May 17, 2001
Messages
110
Helped
17
Reputation
34
Reaction score
4
Trophy points
1,298
Location
Spain
Activity points
795
Hi all
I have been playing with this new app and I have faced a serious problem: the linux FEM engine is completely messed up. I'm unable to analyze a simple microstrip step transition (from the manual) because emds_bond always barfs. 2009 version is fine. Using it, I can even analyze the LTCC Marchand balun example from 2009u1.
I can live without FEM engine, well I can live without Momentum engine too but I want to know if anyone out there has faced the same problem.
TIA
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top