Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADS question for S parameters of CPW

Status
Not open for further replies.

asmodeus

Newbie level 6
Joined
Aug 16, 2009
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Bristol
Activity points
1,354
cpw ads

Hello. I want to check the s parameters of a CPW. The question is how can i create a CPW of 5mm length that will gradually increase the width of conductor (W) from 140um to 330um and gaps (G) from 63um to 139um? These are the dimensions of my CPW calculated from line calc in order to have 50Ω matching
 

Manjunatha_hv

Advanced Member level 3
Joined
Aug 3, 2005
Messages
810
Helped
240
Reputation
480
Reaction score
122
Trophy points
1,323
Location
INDIA
Activity points
8,691
Hello,

use the CPW TAPER element...
see the attached picture of your structure layout & Schematics...

By the ay what is your CPW substrate parameters & frequency sweep to get this S-Parameters?

---manju---
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top