Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Add probe pads to antenna

Status
Not open for further replies.

icpinu

Junior Member level 2
Joined
Nov 26, 2010
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,450
Hi,

I am quite new on antenna design but I have been able to design a mm-wave antenna on ADS. I am going to test is with GSG probes and would like to know what is the procedure to add this to the antenna.

Should I add the probes on my EM simulations?
If so, how do I do this? Currently I have designed the antenna with a cpw feed with a 50 ohm impedance.

Many thanks for the advice
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top