AC to DC power supplies without banana plugs: how do you connect wires to it?

[lduren]

Hello,

This is a basic question I am sure. I saw a power supply that I am interested in purchasing. It is the HP (Agilent) 6033A. It ranges from 0 to 20 volts and 0 to 30 amps, 200 watts. The pictures of it do not show banana plugs where power and ground plugs would normally be inserted. How do you plug in power cables to this power supply?

Here is a link to HP 6033A pictures:

https://www.google.com/search?q=hp+...34G4Dg&ved=0CAsQ_AUoAw&biw=1366&bih=598&dpr=1

Thanks

Lee

 

[zuisti]

The pictures of it do not show banana plugs where power and ground plugs would normally be inserted. How do you plug in power cables to this power supply?

Look at the fourth picture on this site:
**broken link removed**
The output power plugs are on the rear.

And here is the service manual (also shematics):
**broken link removed**

 

[tpetar]

Hello,

This is a basic question I am sure. I saw a power supply that I am interested in purchasing. It is the HP (Agilent) 6033A. It ranges from 0 to 20 volts and 0 to 30 amps, 200 watts. The pictures of it do not show banana plugs where power and ground plugs would normally be inserted. How do you plug in power cables to this power supply?

Here is a link to HP 6033A pictures:

http://www.google.com/search?q=hp+6...34G4Dg&ved=0CAsQ_AUoAw&biw=1366&bih=598&dpr=1

Thanks

Lee

Check back side:

**broken link removed**

Service Manual
**broken link removed**


Best regards,
Peter