Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

A question about the gilbert mixer design

Status
Not open for further replies.

oliver_zhang

Newbie level 6
Newbie level 6
Joined
Jul 7, 2006
Messages
11
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,350
Hello, can anyone help me to solve the ADS simulation problem.I designed a gilbert mixer,please refer to the attachment.In my simulation,the NF is too big,and when I tried to do optimization,the ADS hint me that the matrix of the NF can't converget.Any help will be appreciated.
 
Dear oliver
i have checked ur circuit ,and the setup , and also check the ADS simulation example for Mixer Noise figure i found that u use the LO is port 2 , and the IF is port 3
and in the example setup , ADS make LO is port 3 , and the IF is port 2
i have modified this , and it gave me a very resonable value

check the attached pic

Khouly
 

Dear khouly,
Thank you very much. You are so kind:).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top