Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The error messages are clear enough, I think: those parameters {cox,csub,rsub}_{1,2} can't be found, hence aren't declared. You should define them in the parameters section.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
![eetop[3].JPG](https://www.edaboard.com/data/attachments/9/9943-bfbc498c0a55aad5bf06ba9090090e6b.jpg "eetop[3].JPG")
