A hole for Plastic pin of ethernet connector

Status
Not open for further replies.
B

baby_2

Advanced Member level 4
Joined
Jul 20, 2016
Messages
105
Helped
2
Reputation
4
Reaction score
1
Trophy points
18
Activity points
873
Hello,
Here the ethernet connector(http://www.kosmodrom.com.ua/pdf/HR911105A.pdf) that I am going to implement in Altium.

I need to know that for plastic connector (phi=3.25) if my configuration is right. (hole size=3.25 , X/Y for round shape=2.5)



 

No. You'll use non-plated hole for mechanical alignment or locking pins, without annual ring etc.
 

Thank you for your response. It means just by adjusting the hole size and disabling plated option ( even annual ring=0?) it works fine?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…