Jay23
Newbie level 5
Hi All,
I am using quad 2:1 to control 3 relays. as the input signals to the mux are comming from 2 different uCs.
The mux has these config.
pin 15 is Enable
pin 1 Select
IN: 2,5,11 and 14
OUT: 4,7,9 and 12
The problem is when the circuit is turned on the relays are switching constantly On and Off.
The relays are SPST type. Enable and Select are grounded.
I am using the config as in the function table for this chip.
appreciate some help on this matter.
I am using quad 2:1 to control 3 relays. as the input signals to the mux are comming from 2 different uCs.
The mux has these config.
pin 15 is Enable
pin 1 Select
IN: 2,5,11 and 14
OUT: 4,7,9 and 12
The problem is when the circuit is turned on the relays are switching constantly On and Off.
The relays are SPST type. Enable and Select are grounded.
I am using the config as in the function table for this chip.
appreciate some help on this matter.