50 ohm transmittion line calculation?

Status
Not open for further replies.
M

modelstudent

Newbie level 6
Joined
Aug 12, 2010
Messages
14
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,370
50 ohm feed line calculation?

hello, i am working on a multiband antenna with subpatch, the main part of the anteena is finished but i dont know how to calculate the feed line dimension, and i just try the dimension one by one now, are there any efficient way that i can get the dimension?
i am using ADS to simulate my antenna.
many thanks!!
 
Last edited:

In ADS Schematic, go to Tools > Linecalc
This is a tool that calculates the required line width.
 

the linecalc only calculate the width of feed line at one operating frequency,doesnt it?
however, my antenna is multiband, which frequency should i input ?will it work?

many thanks~!
 

thats mean i can choose either one to input and get the results?
 

modelstudent said:
after i get the width, then i should adjust the length of the feed line until i get a good S11 results?
Click to expand...

Ooops ... you said that you want a 50 ohm line, so that the line is matched to the 50 ohm source -> no impedance transformation -> length does not matter
 

does the antenna design related to the impedance of feed line?
 
Reactions: saweng

    S

    saweng

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…