ala_einstein82
Newbie level 1
Hi,
I am new to rf design. I'm trying to design a 4 layer PCB.
the stack-up looks like this:
1.GND
2.Power
3.signal
4.GND
the data rate in layer 3 (signal layer) is about 16 GHz.
What do I have to consider?
I mean, what is the best method (draw finite GNDs? vias between layer 1 and 4?) in ADS Momentum 2013.
I would like to get practical and real values.
I have tried several methods but I do not know which method is the best.
I am For every tip very grateful.
Thanks
I am new to rf design. I'm trying to design a 4 layer PCB.
the stack-up looks like this:
1.GND
2.Power
3.signal
4.GND
the data rate in layer 3 (signal layer) is about 16 GHz.
What do I have to consider?
I mean, what is the best method (draw finite GNDs? vias between layer 1 and 4?) in ADS Momentum 2013.
I would like to get practical and real values.
I have tried several methods but I do not know which method is the best.
I am For every tip very grateful.
Thanks