Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Have you decided on the topology, the components, features, etc?
You can use SG3525 and high-low side drivers to drive 2 MOSFETs in half-bridge configuration or 4 MOSFETs in full-bridge configuration. For current sensing you can use a shunt resistor (for full-bridge only) or a current transformer or hall-effect sensor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
