13.56Mhz Class E Power Amplifier for Plasma Generation

Status
Not open for further replies.
yea, 50ohm...i check it, the model is Good Will Instrument, GFG-813...then what should I do on the simulation now?

sorry but i don't get it again, adjust the bias voltage for what?? obtain a square wave from 0V to 12V??
 

Dear keathow
Hi
DO you know the principles of a class E stage amplifier ? the value of VCC has direct effect on efficiency . the amplitude of out put wave at class E can be higher than vcc ( about 9/8 vcc) ( i'm talking about single ended class E amplifier )
So if you don't know it's principles , i can describe the ways of design .
Best Things
Goldsmith

---------- Post added at 03:48 ---------- Previous post was at 03:45 ----------

BTW: i forgot to say , that sine waves as input signal , should has the voltages about 15 volt to be ensure that after threshold voltage , the mosfet isn't at linear region.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…