Thank you, that on is a bit more complicated than what i had thought I might need, I still have to wait a post until i can post my scheme.
---------- Post added at 07:38 ---------- Previous post was at 07:36 ----------
WOW, took a closer look at it and looked at the feedback circuitry and display module. I might be able to simplify it a bit to make it work for me. I took the thought of multiple mosfets from previous posts and applied it to my design as well.....Well, not exactly a design, just a pretty drawing with not much in the way of specs.
BOOYAH
The third mosfet is the potentially optional one, I was reading about how too many can cause a problem with the way the circuit turns on and off, still not exactly sure how to figure that particular point out though.
Also, 87 on the relay goes directly to ground for the bypass. Thats at least one missed little detail that that I found.
Also, I saw a post on the other thread like this where someone recommended a resistor between terminal one and ground, whats the purpose of this, and what would be a good valuve to use.
I am not a total dum-dum with electronics, its just been a while since my electrical components teacher was jambing my brain with info, and i've had not practice with the component level, only the "replace the board/module/widget, it seems bad" end out it.
I sincerely appreciate any and all helpful info though!