eem2am
Banned
i am doing 10w boost smps on 1.5cm by 70cm pcb. (double sided)
it is for 8 to 17V in
27V out.
510KHz swith freq (at the moment)
It must have current controlled output as load is LEDs at 350mA.
There is a 0-5V input which when high, the LEDs must be off.
The trouble is, virtually the entire pcb area (top and bottom) is populated with components. This is making it very hard to ensure go" and return" tracks are next to each other, or directly above and below each other.
does any reader have any recommendations?
it is for 8 to 17V in
27V out.
510KHz swith freq (at the moment)
It must have current controlled output as load is LEDs at 350mA.
There is a 0-5V input which when high, the LEDs must be off.
The trouble is, virtually the entire pcb area (top and bottom) is populated with components. This is making it very hard to ensure go" and return" tracks are next to each other, or directly above and below each other.
does any reader have any recommendations?