Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PSRR in the LDO --------- need help

Status
Not open for further replies.

poweric

Member level 5
Member level 5
Joined
Oct 29, 2006
Messages
80
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,286
Activity points
1,733
I am simulating a LDO the supply voltage is 3.3v
The psrr+ of the ldo is 89db
but the psrr- of it is only 4db

is it the necessary to simulate the PSRR-
and the 4db is too small??
 

I don't know whether PSRR- is necessary or not, but -4dB isolation is very small as of my knowledge. It should be around -70dB or above
 

Basically, in My experience I try to set the PSRR at around 80dB
 

great c connect to gnd
so psrr to gnd is bad
but 4dB is too small
 

BUT I HAVE THE QUESTION
if the psrr-( vout vs gnd) is large such as (-70db)
when the gnd became larger ,the vout become smaller than the gnd
how can i get the vout as my reference because the vout-gnd is reference voltage

if the if the psrr-( vout vs gnd) is small such as (-4dcb)
when the gnd is float the vout become larger the vout become large as the gnd
but the vout-gnd may keep a constant value as my reference


this is my idea for the question
hope for your replies
 

I think PSRR- is not necessary and if u do it it shows very less, bcoz only R's in that sig path..
in case of source ,sink ldo which is capable of providing i in both dirs then psrr from + and PSRR- id=s very imp concerns.
 

i know
thans for your helps
 

you LDO can have so good PSRR? my design ouly -50~60dB

gelo said:
Basically, in My experience I try to set the PSRR at around 80dB
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top