Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

İ can't stimulate in pspice.

Status
Not open for further replies.
M

maglev89

Newbie level 2
Newbie level 2
Joined
Apr 3, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,292
İ am designing any circuit But it give error when i run it



Here is screenshots:

**broken link removed**

**broken link removed**

**broken link removed**






______________________


İ think i cant find right ground. Because there is no source ground in library...
 
Last edited:

Try connecting node zero to the node named GND with a zero volts voltage source (or very low value resistor).

Keith
 

I don't normally use Pspice but you need a node zero. Either rename your GND to be called 0 or select the 0 component out of the SOURCE library.

Keith.

 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top