Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem in Updating PCB from Schematic in Altium Designer

Status
Not open for further replies.
M

madnaveen

Newbie level 6
Joined
Oct 28, 2006
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,369
Hello,
I am facing a strange problem and am unable to resolve it. I have made a schematic and after i try to update the PCB, a few of the nets are not getting exported. This problem is happenning only to the components that i have created and assigned nets to. is there some problem the way i am creating the componets in the schematic library? The pins in the component seem to behaving different net names than the names i assign to the wires. Is this the likely problem? How do i go about resolving this?
Thanks
Naveen
 

Re: Problem in Updating PCB from Schematic in Altium Designe

It has to do with the pins in the components. They should be other way around :D
 

    M

    madnaveen

    Points: 2
    Helpful Answer Positive Rating
Re: Problem in Updating PCB from Schematic in Altium Designe

Place manual junctions at newly created nets and parts.
Delete the PCB file(make a backup of the project first).
Create a new pcb file.
Now update the new PCB file.
Hopefully your problem will be resolved.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top