Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Isolation level of isolated DCDC module?

Status
Not open for further replies.
T

treez

Guest
Hello,
We need an isolated DCDC module to give 15V output from a 13V input. Its to provide isolated power to a DALI comms bus from a non mains isolated source.
We need full mains isolation. This is usually described as being able to withstand a hi-pot test at “3000VAC at 50Hz for one second”.
The Traco TEN 3-1213 DCDC module gives isolation of “1500VDC for one second”.
Do you think that this is therefore safe to use for our DALI comms bus? (ie, does it equate to full mains isolation)?

Traco TEN 3-1213 DCDC module datasheet:
https://www.farnell.com/datasheets/...086.845751712.1519485949-287702491.1506211291
 

Hi,

I doubt it is according safety regulations.
15V is low voltage and 13V is low voltage....both are not dangerous.

In opposite to an AC/DC module with 230VAC input, which clearly is dangerous voltage.

I recommend to find out what regulation(s) is valid for your application.
Then contact Traco if the DCDC converter complies with this regulations.

Klaus
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
In fact, ive dug out a DALI spec which says..
The minimum requirement for system components conformant to this standard shall be basic
insulation as defined in IEC 61347-1.
Click to expand...

But we dont have IEC61347-1 and it costs £120.
 

Attachments

  • IEC 62386-101-2014 - DALI - Part 101 General Requirements - System components.zip
    986.3 KB · Views: 59

treez said:
But we dont have IEC61347-1 and it costs £120.
Click to expand...

Are you a hobbyist or a legitimate company? Like, where you sell products to the public? And you're too cheap to spend a pittance on properly validating your design? That's just unbelievable.
 
  • Like
Reactions: d123 and treez

    T

    Points: 2
    Helpful Answer Positive Rating
    d123

    d123

    Points: 2
    Helpful Answer Positive Rating
The Traco TEN 3-1213 DCDC module gives isolation of “1500VDC for one second”.
Click to expand...
Datasheet says 1500VDC 60 seconds...

As far I'm aware of, IEC61347-1 specifies clearance and creepance but no test levels. You may refer to other safety standards, e.g. EN61010.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top