Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I usually build my own pads even if library pads are
available, since everything is custom routed for performance
and reliability in such circuits.
Figure your allowed bond wire current to get # of pads
and then check electromigration on the feed layout, from
VIN to OUT, every feature along the way (including the
pad fillet and a circle drawn around the bond wire "foot".
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
