Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
CAN uses dominant/recessive level concept, not possible with RS485 driver. Read about CAN basics.
A similar behavior can be possibly achieved when sending through transmit enable pin, with supporting pull-up and pull-down resistors, but not exactly complying with CAN standard.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.