Anklon
Member level 1
I'm currently doing an university project to design a chip. We are creating our own standard cell library for that purpose. I need some information/ direction to design end-cap cells.
I know what is end-cap cell is. But I don't know where to look for proper rule information to design them ( like width or height for cells for a particular technology ).
I googled it for hours, but most of the time come up with the definition rather then detail design information. my design rule document file do not contain any information about well tie-off errors.
Any resource or link would be appreciated. Thanks for your time.
I know what is end-cap cell is. But I don't know where to look for proper rule information to design them ( like width or height for cells for a particular technology ).
I googled it for hours, but most of the time come up with the definition rather then detail design information. my design rule document file do not contain any information about well tie-off errors.
Any resource or link would be appreciated. Thanks for your time.