fouwad
Full Member level 4
Hello I am using a PCI based parallel card to program my FPGA as provided by the manufacturer. The software readme.txt says to change the parrallel port address to 0x378 to run the burn software.
I am using Dell Optiplex 9010 with A13.0 Version of BIOS. I am unable to find the change of Address settings in my BIOS. can anyone help me with this issue. Thanks
I am using Dell Optiplex 9010 with A13.0 Version of BIOS. I am unable to find the change of Address settings in my BIOS. can anyone help me with this issue. Thanks