slutarius
Full Member level 5
Hi guys,
I am new to MicroBlaze and app SDK of Vivado.
I want to write an application, say in C, to test my hardware IP which was generated from Vivado.
The hardware is an MicroBlaze with Uart IP connected via a AXI interconnect. Other component are clock and reset support, MIG to connect with DDR3 IF.
My questions:
I dont have a board now, so can I test my program on Vivado SDK without a board ?
Is there monitoring conponent to capture uart data and so on ?
It keeps saying that I need a board to run the test application.
Thanks,
I am new to MicroBlaze and app SDK of Vivado.
I want to write an application, say in C, to test my hardware IP which was generated from Vivado.
The hardware is an MicroBlaze with Uart IP connected via a AXI interconnect. Other component are clock and reset support, MIG to connect with DDR3 IF.
My questions:
I dont have a board now, so can I test my program on Vivado SDK without a board ?
Is there monitoring conponent to capture uart data and so on ?
It keeps saying that I need a board to run the test application.
Thanks,