Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need such a DAC to put in feedback of sigma-delta modulator i.e. between Q output of D-latch and difference junction. That signal is compared with reference voltage of 155 VAC.
I think you are using the dac for delta modulation or sigma-delta modulation.
Note: It is very important for you to know that also this dac has only 1-bit, the resolution for the dac has to be as "linear" as your overall adc!! However, for a 1 bit you will always get perfect linearity. But therefore the signal source of the dac (the voltage reference) has to keep constant, especially not signal dependent!!
Therefore use switches (or switch arrays) and a buffered voltage refernence.
If I'm wrong with my assumption, a simple comperator will do it!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.