Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What happens if the value of torque crosses pull-out torque?

Status
Not open for further replies.
D

DrDolittle

Full Member level 3
Joined
Sep 24, 2004
Messages
162
Helped
5
Reputation
10
Reaction score
1
Trophy points
1,298
Location
Within arm's reach
Activity points
1,443
Pull-out torque

can somebody tell what happens to the synchronous generator when in the speed-torque curve,the value of torque crosses pull out torque.Will there be a motoring action or a generating action?

Regards
drdolittle :)
 

Re: Pull-out torque

hmmm... i guess that once the torque crosses the pull-out torque, the load angle delta becomes too large for synchronism to be maintained...
 

Re: Pull-out torque

rkarthik1 said:
hmmm... i guess that once the torque crosses the pull-out torque, the load angle delta becomes too large for synchronism to be maintained...
Click to expand...

Yes that's right. In that case we lost synchronism immediately .
 

Re: Pull-out torque

ya...once load torque crosses the pullout torque ,the synchronism lost..also it will immediately reach the standstill condition...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top