Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Converting dxf into pads

Status
Not open for further replies.
M

Monolisa5791

Member level 3
Joined
Jun 14, 2006
Messages
65
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,962
Hi All,

When i converting the dxf into pads layout is there any way to bring traces as a trace properties from aitocad file.

Regards,
Monolisa
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top