somayeh
Newbie level 5
"Done pin didn't get high" error when programming Spartan 2 in slave serial mode
hello
Do somebody help me ?
My problem is about programing Xilinx Spartan 2 (xc2s150 )
I program it by ISE 6.3 software
when it's programming in mode slave serial,give a error massage.
Done pin didn't get high.
even the pin is connected VCC with resistor 3.3K but there is a error massage.
THE error is
Done pin didn't get high.
hello
Do somebody help me ?
My problem is about programing Xilinx Spartan 2 (xc2s150 )
I program it by ISE 6.3 software
when it's programming in mode slave serial,give a error massage.
Done pin didn't get high.
even the pin is connected VCC with resistor 3.3K but there is a error massage.
THE error is
Done pin didn't get high.