Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Do you need key parameters for BSIM Model simulation?

Status
Not open for further replies.
T

tfwee

Member level 1
Joined
Sep 7, 2005
Messages
35
Helped
6
Reputation
12
Reaction score
2
Trophy points
1,288
Activity points
1,625
BSIM Model

If I am using BSIM model for simulation. Do I need to key parameter like AD, AS, PD and PS. Does BSIM model account for these parameters in the simulation?
 

BSIM Model

In pre-layout this will not impact much on your simulation. Post layout u will have extracted netlist in which it's AD AS PD PS will be included. BSIM model support this parameter.
 

BSIM Model

In pre-sim, BSIM3 provides parameter for simulators to enable/disable the calculation of AD, etc. So you can just specify L/W for MOSFET.

In post-sim, use extracted AD, etc for better match with real chips.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top