Winsu
Full Member level 3
Hi All,
I am not sure if this is the right place to post this question. I need to unsolder a DFN-8( package ) regulator from an board. After that I will have to solder another one, as I think it is not regulating at all. The board is already populated so put it back in a reflow machine is not a good idea. How I could remove the regulator without damaging other components. I have a hot air gun and hot plate....
Thanks,
Winsu
I am not sure if this is the right place to post this question. I need to unsolder a DFN-8( package ) regulator from an board. After that I will have to solder another one, as I think it is not regulating at all. The board is already populated so put it back in a reflow machine is not a good idea. How I could remove the regulator without damaging other components. I have a hot air gun and hot plate....
Thanks,
Winsu