jfminformatica
Junior Member level 3
I suspected the integrated TNY278 that I tried to replace with a new one but after replacing the component the defect persists.
The voltage on the green wire at the source output does not exist.
The voltage over the electrolytic capacitor of primary after the rectifying bridge is around 175V (B+) or so.
I tried to find the schematic diagram but couldn't
The voltage on the green wire at the source output does not exist.
The voltage over the electrolytic capacitor of primary after the rectifying bridge is around 175V (B+) or so.
I tried to find the schematic diagram but couldn't