clros
Member level 2
In this simulation (I am using multisim 14.0), the output voltage value (measured from XMM1) multimeter is:
~0V when S1 is on VDD
~0V when S1 is on GND
3.3V when S1 is on VSS
But, if I make this circuit on Breadboard whit a real VP0808, it do not faithful to simulation (I have 3.3V when S1 is on GND).
Is it a simulator error?
~0V when S1 is on VDD
~0V when S1 is on GND
3.3V when S1 is on VSS
But, if I make this circuit on Breadboard whit a real VP0808, it do not faithful to simulation (I have 3.3V when S1 is on GND).
Is it a simulator error?