+ Post New Thread
Results 1 to 3 of 3
  1. 12th November 2019, 11:22 #1
    baby_2
    baby_2 is offline
    Full Member level 1
    Points: 1,109, Level: 7
    Join Date
    Jul 2016
    Posts
    105
    Helped
    1 / 1
    Points
    1,109
    Level
    7

    A hole for Plastic pin of ethernet connector

    Hello,
    Here the ethernet connector(http://www.kosmodrom.com.ua/pdf/HR911105A.pdf) that I am going to implement in Altium.

    I need to know that for plastic connector (phi=3.25) if my configuration is right. (hole size=3.25 , X/Y for round shape=2.5)

    Click image for larger version.  Name: 20.PNG  Views: 0  Size: 16.8 KB  ID: 156461

    Click image for larger version.  Name: 25.PNG  Views: 1  Size: 11.1 KB  ID: 156462
    Reply With Quote Reply With Quote
    •   AltAdvertisement

        
       
  2. 12th November 2019, 11:27 #2
    FvM
    FvM is offline
    Super Moderator
    Points: 262,035, Level: 100
    Awards:
    1st Helpful Member
    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    45,803
    Helped
    13925 / 13925
    Points
    262,035
    Level
    100

    Re: A hole for Plastic pin of ethernet connector

    No. You'll use non-plated hole for mechanical alignment or locking pins, without annual ring etc.

    Reply With Quote Reply With Quote
    •   AltAdvertisement

        
       
  3. 12th November 2019, 12:39 #3
    baby_2
    baby_2 is offline
    Full Member level 1
    Points: 1,109, Level: 7
    Join Date
    Jul 2016
    Posts
    105
    Helped
    1 / 1
    Points
    1,109
    Level
    7

    Re: A hole for Plastic pin of ethernet connector

    Thank you for your response. It means just by adjusting the hole size and disabling plated option ( even annual ring=0?) it works fine?

    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »
Powered by vBulletin
Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.
--[[ ]]--