Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am required to use very uneven power divider in my power amplifier design. Is very thin width of the transmission line is realizable practically (w=0.05 mm)? Attached is the layout of power divider designed
What is the coupling ratio? Maybe it's easier to just use a resistive divider in parallel to the main line, if the coupling is that small. The resulting mismatch is small then.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.