Chinmaye
Full Member level 3
Hello all,
I am trying to perform a test AMS simulation. After ADE launch, we go to setup->Connect rules. There i see a set of standard rules like 18_full_fast, 5_full_fast etc. All of these have logic low of 0V and logic high of 5V/1.8V etc. My requirement is that I would like to have a logic low of -900mV and logic high of 900mV. Is there a way out?
I am trying to perform a test AMS simulation. After ADE launch, we go to setup->Connect rules. There i see a set of standard rules like 18_full_fast, 5_full_fast etc. All of these have logic low of 0V and logic high of 5V/1.8V etc. My requirement is that I would like to have a logic low of -900mV and logic high of 900mV. Is there a way out?