Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What tools are you using for simulation and extraction? Dependent on that you have different means of back-annotation to your original schematic/layout and can (or cannot) directly probe in the extracted view (PVS/Assura). Using calibre requires a different approach.
Are you doing RC extraction or just capacitive extraction? The latter is a bit simpler as the node names are often consistent. But since you aim for DC operating points, I assume you run R extraction of some kind.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.