+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Newbie level 2
    Points: 28, Level: 1

    Join Date
    Jun 2018
    Posts
    2
    Helped
    1 / 1
    Points
    28
    Level
    1

    pad and via holes in altium 18

    I'm working with Altium 18.
    pad holes are not visible as shown in figure below
    Click image for larger version. 

Name:	Capture.PNG 
Views:	0 
Size:	59.2 KB 
ID:	147510

    anybody knows how to make the holes visible?
    thanks in advance

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 29,643, Level: 41
    andre_teprom's Avatar
    Join Date
    Nov 2006
    Location
    Brazil
    Posts
    8,863
    Helped
    1115 / 1115
    Points
    29,643
    Level
    41
    Blog Entries
    9

    Re: pad and via holes in altium 18

    Did you try by checking "drill drawing" at View Configuration panel, Board Layers and Colors tab ?
    --------------------------------------------------------------------------------------------------
    Part of the world that you live in, You are the part that you're giving ( Renaissance )


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  3. #3
    Newbie level 2
    Points: 28, Level: 1

    Join Date
    Jun 2018
    Posts
    2
    Helped
    1 / 1
    Points
    28
    Level
    1

    Re: pad and via holes in altium 18

    Yes it is checked andre!
    But I found it!
    I knew that I should check "pad hole" and "via hole" somewhere to make them visible.
    I had looked at View Configuration several times before but I couldn't find them.
    After you referred me to this panel again I found their locations accidentally.
    They were collapsed under "system colors" as shown in picture below
    Click image for larger version. 

Name:	Capture.PNG 
Views:	2 
Size:	88.2 KB 
ID:	147514
    As I click on it the picture below appears and I can check them
    Click image for larger version. 

Name:	Capture.PNG 
Views:	1 
Size:	31.6 KB 
ID:	147515

    Thank you andre for your help.


    1 members found this post helpful.

--[[ ]]--