dhivya34
Junior Member level 1
Hi
The DUT has 3 modes.
Based on the mode selected, the definition of certain registers within a particular address range changes.
Physically separate registers exist for each of the register definition.
But because of limited address space, based on the mode selected, a common address is used to address the registers for read/write.
This is a way of indirect addressing.
So looking straight foward, a single address would be used to address 3 different registers ( the mode selects the exact register)
Could anyone tell me how to generate a RAL model for this.
Thanks
The DUT has 3 modes.
Based on the mode selected, the definition of certain registers within a particular address range changes.
Physically separate registers exist for each of the register definition.
But because of limited address space, based on the mode selected, a common address is used to address the registers for read/write.
This is a way of indirect addressing.
So looking straight foward, a single address would be used to address 3 different registers ( the mode selects the exact register)
Could anyone tell me how to generate a RAL model for this.
Thanks