heena123
Banned
hi,
I am using PIC18f46J11 and PIC18f24j11 (both are same) pic micro controller ,
I write a code in Both C & Assembly language to interface a LCD.
I am using local LCD and other is FOR DATA LCD .
But it not Initialized or display anything on LCD Display
Both LCD pin Configuration and VCC supply voltage is different Local is work on 5 V and Other one is work On 3..3V
When i used local i gave my data and Control pin On PORT D * B which have 5V Tolerances.
I attached My simple schematic also in .RAR 7 ZIP format.
I also Used PMP Mode of PIC18f
All are simulate and working properly.also data and command are coming on port with delay.
But i am stuck where i am goes wrong.
Please guide me....
Regards,
Heena.
I am using PIC18f46J11 and PIC18f24j11 (both are same) pic micro controller ,
I write a code in Both C & Assembly language to interface a LCD.
I am using local LCD and other is FOR DATA LCD .
But it not Initialized or display anything on LCD Display
Both LCD pin Configuration and VCC supply voltage is different Local is work on 5 V and Other one is work On 3..3V
When i used local i gave my data and Control pin On PORT D * B which have 5V Tolerances.
I attached My simple schematic also in .RAR 7 ZIP format.
I also Used PMP Mode of PIC18f
All are simulate and working properly.also data and command are coming on port with delay.
But i am stuck where i am goes wrong.
Please guide me....
Regards,
Heena.