RedAlert
Member level 1
- Joined
- Oct 13, 2001
- Messages
- 38
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,286
- Location
- Somewhere in Israel
- Activity points
- 176
I am planning a board which has upto 20 IC(Through hole) as a prototype on a wire-wrap board.
will use wire-wrap wires and my question is related to the power distribution network; since I am not using PCB and thus power/gnd planes not relevant, so will use power/gnd bus, how it is recommend to connect the power and gnd wires for ths various IC?
Should I use, for example, two row header with some pins and for every pin will connect the IC power/gnd pins, or connect the power/gnd wires from one IC to other?
Is it also recommend to overlap the power and gnd wires together all over the board till the IC power/gnd pin to reduce power noise?
Thanks in advance.
will use wire-wrap wires and my question is related to the power distribution network; since I am not using PCB and thus power/gnd planes not relevant, so will use power/gnd bus, how it is recommend to connect the power and gnd wires for ths various IC?
Should I use, for example, two row header with some pins and for every pin will connect the IC power/gnd pins, or connect the power/gnd wires from one IC to other?
Is it also recommend to overlap the power and gnd wires together all over the board till the IC power/gnd pin to reduce power noise?
Thanks in advance.