tonymontana
Newbie level 1
I designed I2S transmitter in VHDL to control AD1939 codec. My question is that;
Is it possible to hold DAC output in certain level such as 2 volts, while disabling bit clock signal or I2S protocol works only continuous mode? I mean that if i want to hold dac output level in certain voltage level
*i should send same data over and over again or
* i have choice to stop data transmission by disabling bit clock signal?
Best regards!
Is it possible to hold DAC output in certain level such as 2 volts, while disabling bit clock signal or I2S protocol works only continuous mode? I mean that if i want to hold dac output level in certain voltage level
*i should send same data over and over again or
* i have choice to stop data transmission by disabling bit clock signal?
Best regards!