Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to perform Load Pull Simulation in ADS?

Status
Not open for further replies.
C

chinym33

Newbie level 1
Joined
Sep 17, 2007
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Ya...I know there is a design guide, but when I open up I'm confused by the way it can be done for the simulation? Could anybody has the step by step guide for me to refer?

your help is much appreciated.
 

Try to use "loadpull design guide" ( if you have this license) ..
It will set-up all necessary circuit(s) for you..
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top