Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Setup and Hold violation for the same register?

Status
Not open for further replies.
K

kris2552

Newbie level 4
Joined
May 12, 2008
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,323
Hi

Could any body please tell me ...Is there any chance of getting both setup and hold viloation for the same register(for the same path)? If so what could be the solution?

Thanks in advance.
 

if the input of the ff is a asynchronism signal, it is possible.
for synchronous signal, the same path, I don't think so,
but the input of the ff may come from several different source, for example the input d=a and b,
for a path, setup error
b path, hold error
which is possible, you can fix the two different path separatly
 

to the same ff, yes.. both setup and hold violations can occur because they are coming form different paths... (a slow path and a fast path).

setup and hold violations on the same path (exactly the same path)... i don't think there can be... i just don't see this happening.
 

I agree with them.
I think this only occur in a small part of the path.
So, you can fix this separately.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top