Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

need a NC Tactile pushbutton 6mm square

Status
Not open for further replies.
sherazi

sherazi

Banned
Joined
Feb 15, 2010
Messages
388
Helped
61
Reputation
126
Reaction score
61
Trophy points
1,318
Location
Muscat, Oman, Oman
Activity points
0
I needed a NC Tactile pushbutton in a project, I layed the PCB design and sent it to the FAB House and then I found that its very hard for them to find the Normal closed Tactile push-button.I needed a push-button that was normally closed (NC) and would open when pushed. Almost every tactile push-button is normally open (NO) and closed when pushed.So, does anyone know of a standard-width, compact-height, through-hole, tactile push-button in a normally closed state? I am using 6mm square tactile Push-button footprint.
http://teeblog.blog.com/archives/253/
 

I think, the restriction to N.O. is given by the design principle of these switches, that use spring disc ("contact dome") as contact element. I fear, you won't find a different type, "hard to find" misses the point. I would rather think about inverting the signal in some electronical way. In some situations, a depletion mode MOSFET may be helpful as a N.C. acting electronic switch.
 
Last edited:

so i got some replies on the post also, i think its better to share that here ...

the one with 6x6mm Nc from a chinese brand omtron electronics. ?-??? ??-???????...?




you can keep check the post for updated links http://teeblog.blog.com/archives/253/
in smd u can find an american brand E-switch
 
Last edited:
  • Like
Reactions: FvM

    FvM

    FvM

    Points: 2
    Helpful Answer Positive Rating
Interesting, none of the major manufacturers, e.g. OMRON ever offered a N.C. type. Thanks for sharing the info.

Presuming, the device uses a contact dome, too. I'm curious if it achieves the same reliability the N.O. types are known for.
 


I am not aware where are you from. But if your requirement is the same as it is shown in the picture in the link in your first post, such tact switches with different knob length's are available through out 90% of component vendors across India. Cheers
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top